How To Get Started - Simrad CE34 ChartSounder Manual

CE34/44/54 Introduction and safety summary

1.3 How to get started

When starting up for the very first time, the first time after loading
a new software or after a master reset: Make sure that all hardware
installation and electrical connections are completed in accordance to
the installation instructions.
Press and hold the [PWR] key until you have a picture on the screen
PWR
The system will perform a software update and check for communica-
tion activity. When finished, a new start-up window will be presented
on the screen:
After making sure that all connected products are turned ON:
Press [ENT] to start automatic input source setup, - if a new product is
ENT
connected later on, refer to section 8.5 Interface setup.
New window: Automatic input source setup listing Data type, Group
and Source of connected units.
Press [ENT] to continue
ENT
Press [PAGE] to scroll through a quick guide which informs of the use
PAGE
of the keys and where you can enter owner's setup, etc.
- the quick guide is also accessible via [MENU], [6], [5].
Press [ENT] when ready to assume normal operation
ENT
- go to [MENU], [6], [2] if you wish to make adjustments to the inter-
face setup.
Automatic input source setup
Interface has not been set up!
To start automatic input
source setup, make sure that
all connected products are
turned ON, and press ENT.
Chapter 1-3
∆
Start
ENT