Highway Display And Navigation Setup - Simrad CE34 ChartSounder Manual

CE34/44/54 Pilot menu & navigation examples

5.2 Highway display and Navigation setup

MENU
Call up the menu bar, and...
load Highway display
3,1
When there is no navigation mode active, you will receive the
legend: NAVIGATION IS OFF.
Before starting out in one of the navigation modes, it may be a good
idea to check out the Navigation setup display and see if the default
settings will suit your need.
Load Navigation setup
ADJ
Navigation setup:
Anchor alarm distance:
WP circle alarm:
WP and cursor navigation:
XTE alarm:
Navigation mode:
Route navigation:
XTE alarm:
Auto waypoint shift:
Track navigation:
XTE alarm:
Auto trackpoint shift:
Navigation mode:
+/-
Toggle between available values, or...
key in a new alarm limit
0-9
Confirm entry
ENT
Anchor alarm distance - When setting anchor, check/change the
preset alarm distance, etc., so you will be warned in case you drift
too far from the anchored position. The alarm distance can be set to
anywhere between 0.01 and 9.99nm. See also section 5.10 Anchor
guard. The alarm will automatically reset once you are inside the
limits again.
WP circle alarm - forms a circle around each waypoint, and the
alarm distance can be set to anywhere between 0.01 and 9.99nm.
00.50nm
00.10nm OFF
00.10nm ON
RHUMBLINE
OFF
WP-circle
00.10nm OFF
WP-circle
RHUMBLINE
Chapter 5-3