Simrad CE34 ChartSounder Manual page 120

Chapter 7-22
Receive WPs and routes
Press [7] to enable reception of waypoints and routes from the plan-
7
ning program
The transmission of waypoints and routes can now be activated from
the PC program. The info window below will inform you of the
progress of the reception of data by keeping an eye on the counter.
When the counter stops, means that all the data from the PC plan-
ner has been collected. However, some PC programs may continue
to transmit the same data over and over again and will have to be
stopped by pressing [ENT].
Receive WPs and routes
Reception in progress
37 WPs received
5 routes received
Stop and save
ENT
- will stop collecting data (if not already finished) and start saving
the collected data.
Waypoints/routes transmitted to the CEXX are added to the WP/
route list. However, if two waypoint/route names are identical, the
latest transferred one will not be saved, even though position(s) may
be different. Routepoints will not be included in the WP list.
Saving the collected data can take anywhere from less than a second
and up to a few minutes, depending on the amount of data. If it takes
too long and you need the CEXX in a hurry, then press the [MENU]
key to Stop saving any more data - what has been saved until this
point will stay in the memory, the rest will be lost.
Stop saving
MENU
Under normal circumstances we assume the saving procedure is
allowed to finish and will indicate "Saving completed" in the info
window. You are now ready to:
Exit function and return to normal NMEA communication
MENU
Stop and save
CE34/44/54 Waypoint / route menu
ENT