Simrad CE34 ChartSounder Manual page 135

CE34/44/54 Setup menu
PLOT
Go to Waypoint interface - step back with [GOTO]
◄
GOTO
Waypoint location input:
Source (none available):
Target Lat/Lon input:
Source (none available):
NMEA0183 output:
Waypoint location:
Routes:
Routes:
MENU
Source - will indicate how many units are connected and available.
NMEA0183 output - see also section 8.5.1 Description of sentences.
PLOT
Go to Alarm interface - step back with [GOTO]
◄
GOTO
Alarm:
Output (REMOTE pin 2,5):
Alarm stand-by level:
MOB-input:
(REMOTE pin 1,5)
Long press (5 sec.):
Short press:
MENU
Stand-by level can either be: LOW = 0 volt or HIGH = 5 volt.
Compass Wind
Exit
Alarm
t SimNet diagnostic
Exit
Waypoint
Ala
WPL
RNN
RTE
Accept
EXTERNAL MOB
Accept
Chapter 8-15
►
PLOT
∆
NONE
NONE
OFF
OFF
OFF
ENT
► Example:
PLOT
CE34
∆
ON
LOW
OFF
ENT