ASCOM d62 Configuration Manual page 61

Configuration Manual
Ascom d62 DECT Handset
No System.
The handset beeps once a
minute with a low tone
followed by a high tone
(during max 30 minutes). If
the vibrator is enabled, it
vibrates after the last beep.
SERVICE NEEDED
Parameters corrupt
Note: This display message is
only shown in English.
SERVICE NEEDED
Invalid IPDI
Note: This display message is
only shown in English.
Enter PIN code
Battery low, charge now
Phonebook is not available at
the moment.
Voice mail number not
defined
08 December 2012 / Ver. H
The handset is out of
coverage,
or faulty handset.
The handset is defective.
Easy replacement procedure
not followed correctly or
failure during easy
replacement procedure.
Phone lock is activated.
The battery level is low.
The phonebook is not
activated or does not
respond.
There is no Voice mail number
defined in the handset.
TD 92639EN
The beeps can be stopped
with the mute button. Then
go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
If this does not work,
contact the system
administrator.
Select the reset option on the
middle soft key and upgrade
the handset's software to
version 3.0.0 or greater. If
this is not available or the
problem persists send the
handset for service.
Send the handset for service.
Enter the required PIN code. If
the PIN code has been lost,
enter a new PIN code via the
PDM/Device Manager or do a
factory reset via the PDM/
Device Manager.
Charge the handset, or
replace or charge the battery.
Try again later or if the fault
persists do a factory reset via
the admin menu or via the
PDM/Device Manager.
Note that it may take several
minutes for the phonebook to
be available if there are many
entries in Contacts and/or
company phonebook.
Define a Voice mail number
via the PDM/Device Manager.
56