Configure Message Alerts With Beep Codes - ASCOM d62 Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
Settings > Display
• Rotate display text
Determines if incoming messages shall be displayed upside down. This can be useful if
you wear the handset in a belt and want to read the message without rotating the
handset. When pressing any key, the messages will be displayed in the normal way.
Note: This setting also affects how incoming calls shall be displayed.

5.26.1 Configure Message Alerts with Beep Codes

The handset can map beep codes sent from a system/an application to different message
alerts. There are several ways to threat the beep codes:
Beeps according to beep code
Beep code sent from a system/application
Beep code 0
Beep codes 1- 6
Beep code 7
The handset will play the original message alerts that are mapped to the beep codes.
1 Select Settings > Sound and Alert.
2 In the Message alert drop-down list, select "Beeps according to beep code".
High beeps according to beep code
Beep code sent from a system/application
Beep code 0
Beep codes 1- 6
Beep code 7
The handset will play the message alerts that are mapped to beep codes but with a higher
tone.
1 Select Settings > Sound and Alert.
2 In the Message alert drop-down list, select "High beeps according to beep code".
Enhanced beeps according to beep code
Beep code sent from a system/application
Beep code 0
Beep codes 1 -3
Beep code 4
Beep code 5
Beep code 6
Beep code 7
The handset will play extended message alerts that are mapped to the beep codes.
1 Select Settings > Sound and Alert.
08 December 2012 / Ver. H
The handset plays:
No message alert is played
1 - 5, and 10 beeps
Siren
The handset plays:
No message alert is played
1 - 5, and 10 beeps
Siren
The handset plays:
No message alert is played
1 - 3 beeps
3 tones chime
10 beeps
Alarm sweep
Siren
TD 92639EN
37