Via Chargers; Over-The-Air Via Ip-Dect - ASCOM d62 Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
2.2.1

Via Chargers

• Connect a desktop charger (DC4) or a rack charger (CR3) via the Ethernet port to the
network.
The charger is by default configured to connect to the network using DHCP. If DHCP is not
used in the network, connect each charger via USB to a PDM Windows Version and
configure a static IP address.
• Start the Device Manager.
• Place the handset in a charger that is connected to the Device Manager. The handset can
either be turned off or turned on when placing it in the charger. A handset that is turned
off will start up automatically and the battery charging symbol will be displayed.
Figure 2. Configuration of handsets via Device Manager and chargers.
2.2.2

Over-the-Air via IP-DECT

There is no external equipment needed besides Device Manager and IP-DECT. Please proceed
to chapter
Figure 3. Configuration of handsets via Device Manager and over-the-air.
08 December 2012 / Ver. H
Figure 2.
Unite module
Device Manager
3 Installation of Handsets
Figure 3.
Ascom
IP-DECT
System
Unite module
Device Manager
IP
Client
on page 8.
IP
Client
TD 92639EN
IPBS
6