ASCOM d62 Configuration Manual page 41

Configuration Manual
Ascom d62 DECT Handset
• Call priority
This parameter determines:
- whether call information presented on the display during incoming, ongoing and
outgoing call shall be suppressed when viewing a message
- whether an ongoing call shall be disconnected when receiving a PTT invitation with
Answer mode set to "Automatically".
0 = Call indication will override all messages and ongoing call is never disconnected
(default).
1-9 = Comparison with message priority; highest priority will be shown and PTT
invitation with higher priority causes disconnection of ongoing call.
10 = Call indication on the display will always be suppressed and ongoing call will always
be disconnected by a PTT invitation.
The tables below show examples of priority settings and how they affect the handset's
behaviour.
Call prio
0
6
2
3
10
10
1.PTT invitation received as incoming call has always priority 6, while PTT invitation received as message
can have priority 1 - 9 depending on configuration.
Table 1. Call prio vs PTT prio
Call prio
0
7
6
1
10
Table 2. Call prio vs Message prio
08 December 2012 / Ver. H
PTT invitation Disconnection of ongoing call?
1
(prio)
1 No, since this call priority setting overrides all
PTT invitations regardless of priority.
6 No, an ongoing call will not be disconnected
when the priority is equal.
1 Yes, immediately since the PTT priority is set to
1 and also is higher than Call priority.
2 Yes, after 10 seconds since the PTT priority is
higher than Call priority.
1 Yes, immediately since the PTT priority is set to
1 and also is higher than Call priority.
2 Yes, after 10 seconds since the PTT priority is
higher than Call priority.
Displayed Message Call information suppressed?
(prio)
1 No, since this call priority setting overrides all
messages regardless of priority.
6 Yes, since the priority of the displayed
message is higher than the incoming call.
6 Yes, since the message is considered as most
important when the priority is equal.
3 No, since the priority of the incoming call is
higher than the displayed message.
1 Yes, the call information will always be
suppress regardless of the message priority.
TD 92639EN
36