Push-To-Talk (Ptt) Group Call; Bluetooth Data Profile - ASCOM d62 Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
NOTE: When registering a handset for the first time in the PDM, the Number (User ID) will be
equal to the handset's extension number. If another user logs on the same handset, the
Number will be unchanged. It is recommended to rename Number to, for example, Shared X
(where X is a number) to prevent number conflict if assigning several shared phone
handsets the same extension when subscribing towards the IP-DECT system. Renaming the
handset in PDM will also make it easier to find and administrate the handset in PDM.
See also the User Manual for Ascom d62 DECT Handset for information on how to log on a
handset.
TIP: It is possible to log off a handset when it is placed in a charger, see
Action when not in Call

5.39 Push-to-Talk (PTT) Group Call

Note: Messaging group(s) must be defined in the IMS3/Unite CM. See the Installation and
Operation Manual for the Unite module being used.
To be able to call a PTT group, its properties must also be set
1 Select "Push to Talk".
2 Select "PTT X" (where X represents the groups 1 to 10)
3 The following parameters can be set:
• Group number - The Messaging group number that is defined in IMS3/Unite CM.
• Display text - This text appears in the display when the PTT group call is
connected.
• Indication - Depending on the handsets in a PTT group, they may receive the PTT
invitation as a message.
• Conference number - The phone number to the conference bridge (PTT server)
that is provided by the system administrator.
• Answer mode - Determines if the PTT call shall be automatically or manually
answered.
• Speaker mode - Determines if the PTT call shall be answered in loudspeaker mode.

5.40 Bluetooth Data Profile

Note: This is a license dependent feature (see
and applicable for d62 Messenger with Bluetooth and d62 Protector with Bluetooth only.
The handset can be configured to receive data from a bluetooth barcode reader and then
send the data to another destination.
See also the User Manual for the Ascom d62 DECT Handset for information on how to
connect a bluetooth barcode reader.
In a template or Number in PDM/Device Manager, the parameters are found at:
Bluetooth Data > Configuration
The following optional parameters can be set:
• Prefix - A prefix (for example "*23*" or "Barcode:") can be sent along with the barcode
data.
• Number - Determines where the data shall be sent.
08 December 2012 / Ver. H
on page 27.
4.4 Upgrade Handset by License
TD 92639EN
5.15.1 In Charger
on page 11)
50