Call Predefined Number Without Sending Alarm; Messaging Settings - ASCOM d62 Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
• Mode for automatic call after alarm
The call can be established in the following modes;
- Normal: the call is established as an ordinary call.
- Loudspeaking: the loudspeaker on the backside of the handset is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to an conversation.
See also 5.24 Common Alarm Settings
Information about the handset's location can also be sent along with an alarm, see
Base Station Positioning

5.25.1 Call Predefined Number without Sending Alarm

It is possible to configure the push-button to dial the automatic call after alarm number
without sending an alarm. The following example describes how to configure the push-
button (alarm on long press). The corresponding settings can also be configured for the
push-button when it is pressed twice or more (alarm on multiple press).
Example of configuration:
1 Select Alarm > Common
2 In the Number for automatic call after alarm field, enter the number to be dialed.
3 Select Alarm > Alarm on long press
4 In the Alarm type for long press drop-down list, select "Not used".
5 In the Mode for automatic call after alarm drop-down list, select one of the following:
- Normal: the call is established as an ordinary call.
- Loudspeaking: the loudspeaker on the backside of the handset is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to an conversation.
This configuration makes it possible to long press the push-button to dial the number
without sending an alarm. However, the push-button can be configured to send an alarm by
pressing it twice (see Alarm type for multiple press in chapter
on page 32).
Information about the handset's location can also be sent along with an alarm, see
Base Station Positioning

5.26 Messaging Settings

NOTE: This feature is applicable for d62 Messenger and d62 Protector only.
It is possible to configure how incoming messages shall be indicated and displayed in
handset. The parameters can be found at:
Settings > Sound and Alerts
• Vibrate alert
Determines if the handset shall vibrate when receiving incoming calls and messages.
• Message alert
Determines the message sound for incoming messages. It is possible to select a
predefined melody (Message 1 - Message 7) or a beep code that represents a certain
sound. For more information on how to configure sounds with beep codes, see
08 December 2012 / Ver. H
on page 32 for additional parameter settings.
on page 29 and 5.20 DECT Location
on page 29 and 5.20 DECT Location
TD 92639EN
5.19
on page 30.
5.24 Common Alarm Settings
5.19
on page 30.
5.26.1
34