ASCOM d62 Configuration Manual page 45

Configuration Manual
Ascom d62 DECT Handset
After 20 seconds, TTP expires for the message with prio 1 and the message is placed in the
queue. The message with priority 2 is shown again and its TTP continues.
TTP expires after 10 seconds for the message with priority 2. In this case, all messages have
been shown 20 seconds each, and the oldest shown message with the highest priority is
displayed (in this case, the message with priority 1). The handset does not indicate when it
shows the message again, since it already has been shown and indicated once. The message
with priority 2 is placed in the queue.
Example 3
This example describes the message handling with the following message settings:
• TTP= 20 seconds
• TTR= 2 minutes
Tip: It is recommended to use these settings if the user shall not be interrupted during 20
seconds while reading a message, unless a message with higher priority is received. When
the user has read a message, its priority is no longer important, that is when TTP expires. In
addition, if a message is not shown again within the TTR interval, it is considered as not
important and is removed from the queue.
New messages
Prio 2
Prio 2
TTP started
TTR started
Prio 2
TTP paused
TTR continues
Figure 7. Message handling without manually closing a message.
In figure 7, a message with prio 2 is received and displayed in the handset, TTP and TTR for
the message is started.
After 10 seconds, a second message with priority 1 is received and displayed while the
message with priority 2 is put in the queue. TTP for the message with priority 2 is paused,
but TTR continues. TTP and TTR for the message with priority 1 is started.
After 20 seconds, TTP expires but TTR continues for the message with prio 1 and the
message is placed in the queue. The message with priority 2 is shown again and its TTP
continues.
TTP expires after 10 seconds but TTR continues for the message with priority 2. In this case,
all messages have been shown 20 seconds each, and the oldest shown message with the
highest priority is displayed (in this case, the message with priority 1). The handset does
not indicate when it shows the message again, since it already has been shown and
indicated once. The message with priority 2 is placed in the queue.
After 80 seconds, the TTR expires for the message with priority 2, and it is removed from
the queue and is indicated as an unread message in the Messaging Inbox. When TTR expires
for the message with priority 1, it is also indicated as an unread message in the Messaging
Inbox.
08 December 2012 / Ver. H
New messages
Prio 1
Prio 1
TTP started
TTR started
Prio 1
TTP expired
TTR continues
20 sec.
Prio 2 Prio 1
TTP and TTR TTP expired
continues TTR continues
Prio 2
TTP expired
TTR continues
10 sec.
TD 92639EN
Messaging Inbox
Prio 2
TTP expired
TTR expired
Prio 2
TTP expired
Prio 2
TTR continues
TTP expired
TTR expired
80 sec.
40