Table of Contents
Advertisement
The underside of the seacock thru-hull is equipped with a scoop to allow the water to be picked
up even when the boat is on plane. When the boat is not in the water or the baitwell pump is not
going to be used for an extended period of time, the seacock valve should be in the closed
position.
To activate the pump, depress the switch to the up or forward position. To turn the pump off
after the baitwell tub is full, depress switch to the down or aft position.
10
Aft Fish Box Pump – Please refer to the instructions provided for the Forward Fish Box Pump
(#6) shown above.
11
Fresh Water – The fresh water switch directs power to the fresh water pump. Depress the fresh
water switch to the forward position to activate the fresh water pump. Then, go to the port aft
corner of the cockpit, retrieve the fresh water faucet/nozzle and press the button on the handle.
If the fresh water system is not going to be in use, move the switch to the down position to turn
the pump off.
12, 13
Accessory - The accessory switches can be used for additional dealer installed accessories.
Please check the amp rating of any new component and/or additional accessory before
installation. These switches are rated for 5 amps.
Lighting Systems
Baitwell Light
The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol on the
switch. To turn on the baitwell light, press the switch forward and open the baitwell to see if the baitwell
light is on. Press the baitwell light switch to the down or aft position to turn off the light.
Cabin Light - Head
The cabin light switch provides power to the light that is located in the head. To operate the light in the
head, depress the cabin light switch on the console to the forward or on position. The light can then be
turned on or off from inside the head by depressing the small button on the base of the light assembly.
Cockpit Lights
The cockpit lights are small circular lights located at the console. Locate
the 2-way cockpit light switch on the switch panel and press the switch in
the forward position to turn on the cockpit lights. Press the cockpit light
switch in the back or aft position to turn the lights off.
Navigation and Anchor/All Around Lights
The navigation and anchor/all around lights are required to be used for operation at night or under low
visibility conditions to indicate your position to other boaters.
navigation and anchor/all around lights and check to be sure that the lights are free from obstructions.
You should check your navigation lights monthly during optimum visibility conditions.
•
When you are underway in low visibility conditions, you should have the Nav/Anc switch
in the up or forward position. This will activate the navigation lights, as well as your
anchor/all around light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor/all
around light.
anchor/all around light.
Press the Nav/Anc switch to the down or aft position to turn on the
Visually verify the operation of your
19
Advertisement
Table of Contents
