Shore Power With Cord; Lighting Systems; Baitwell Light; Bilge Lights - Pro-Line Boats 2010 29 Express Owner's Manual

Blower

Shore Power with Cord

Shore power is used for the operation of AC devices such as your air
conditioner, battery charger, and 110 Volt outlets for other appliances. The
shore power package includes a 25-foot long yellow shore power cord.
The shore power outlet is located on the port wing, aft of the port light and next
to the optional cable outlet. To connect your shore power system:

Turn the shore power outlet fitting and lift it up.

Plug the shore power cord into the outlet on the boat.

Connect the shore power cord to the receptacle at your marina or dock.

Only then should you switch the AC main breaker to on.

If the polarity light (red) is on, unplug the shore power (first at the shore outlet, then at the shore
power outlet on the boat) and do not use it, until a qualified technician corrects this potentially
dangerous situation.
Note: Before attempting to connect to shore power, take precautions to minimize contact arcing
by making sure that the AC main breaker switch is in the off position prior to plugging into shore
power. The AC main breaker is located on the AC panel on the port aft cabin wall.
Please refer to the owner's manual provided by the manufacturer of the shore power unit for operational
procedures and for information related to the care and maintenance of their product. When in doubt, always defer
to the shore power manufacturer's instructions and/or recommendations.

Lighting Systems

Baitwell Light

The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol below. To turn
on the baitwell light, press the switch forward and open the baitwell lid to see if the baitwell light is on. Press the
baitwell light switch to the down or aft position to turn off the baitwell light.

Bilge Lights

The bilge light switch is located on the switch panel and is labeled bilge with a light symbol on the switch. The 2
bilge lights are installed on the port and starboard stringers. Press the switch forward to turn on the bilge lights.
Press the bilge light switch to the down or aft position to turn off the bilge lights.

Cabin Lights

Cabin lights are installed in the main cabin, the mid berth and the head area. The cabin light switch is located on
the AC/DC panel inside the cabin, on the port wall of the main salon. See the section under Electrical System
earlier in this chapter for more information on the AC/DC panel.
Blower Switch Blower Exhaust Vent
22