Table of Contents
Advertisement
For the pump to operate properly you need to make sure the seacock is in the open position.
The seacock is wide open when the yellow seacock lever is vertical. When the yellow seacock
lever is horizontal, the seacock is closed.
The underside of the seacock thru-hull is equipped with a scoop to allow the water to be picked
up even when the boat is on plane. When the boat is not in the water or the baitwell pump is not
going to be used for an extended period of time, the seacock valve should be in the closed
position. To activate the pump, depress the switch to the up or forward position. To turn the
pump off after the baitwell tub is full, depress switch to the down or aft position.
5
Fresh Water (Optional) – The fresh water switch provides power to the fresh water pump.
Depress the fresh water switch to the forward position to activate the fresh water pump. The
fresh water faucet/nozzle is installed behind a white rubber cap located just out side the transom
door. Press the button on the handle to activate the faucet/nozzle. If the fresh water system is
not going to be in use, stow away the hose and move the switch to the aft or down position to
turn the pump off.
6
Cockpit Lights (Optional) – Your vessel may be equipped with cockpit/ courtesy lights. The
lights have LED (light emitting diode) bulbs with a lifespan of approximately 10,000 hours. To
activate the lights, depress the switch to the up or forward position. The lights give off a soft
warm light which should not affect your night vision, but will still provide you with enough light to
safely move around your cockpit in low visibility conditions.
7
Baitwell Light - To activate the baitwell light, depress the switch to the up or forward position.
This will activate the LED (light emitting diode) light inside your baitwell tub. It is a soft white
light that will keep your bait moving and lively. It will also help you locate your bait on those
early morning or late night fishing trips. To turn the light off, simply depress the switch to the
down or aft position.
8
Accessory – This 5 amp accessory switch can be used for additional dealer installed
accessories. Please check the amp rating of any new component and/or additional accessory
before installation.
Lighting Systems
Cabin Light – Head
The cabin light is installed in the ceiling of the head area. The dealer-installed battery provides power to
this light. Press the small button on the base of the light assembly to turn on the light. Press the button
again to turn the light off.
Cockpit Lights (Optional)
The cockpit lights are small circular lights located around the cockpit area near the
helm seat. Locate the 2-way cockpit light switch on the switch panel and press the
switch in the forward position to turn on the cockpit lights. Press the cockpit light
switch in the back or aft position to turn the lights off.
Navigation and Anchor Lights
The navigation and anchor lights are required to be used for operation at night or under low visibility
conditions to indicate your position to other boaters. Visually verify the operation of your Navigation and
anchor lights and verify that the lights are free from obstructions. You should check your navigation lights
monthly during optimum visibility conditions.
17
Hide quick links:
Advertisement
Table of Contents
