Switch And Breaker Panel - Pro-Line Boats 2008 29 Super Sport Owner's Manual

Hide thumbs Also See for 2008 29 Super Sport:
Table of Contents

Advertisement

A tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the on position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.

Switch and Breaker Panel

The switch and breaker panel is located on the console. The numbers shown above or below each
switch in the photo below correspond with the following descriptions provided for each switch:
Circuit Breakers – On the switch panel below the individual switches
7
1
Bilge Pump - Your 29 Super Sport is equipped with an automatic bilge pump and float switch.
This 1100 gph pump is located in the bilge and is accessible via the hinged hatch over the aft
bilge area.
The bilge pump is wired automatic to the battery and has a manual override located at the
switch panel on the console. The automatic float switches are wired directly to the Starboard
battery terminals through breakers or inline fuses. The circuit breaker is located at the helm
next to the manual switches. Depressing the bilge pump switch to the up or forward position
activates the bilge pump.
2
Navigation & Anchor/All Around Lights - Locate the Nav. light switch on the instrument panel.
This is a 3-way switch (forward, middle, back/aft) that functions as follows when you press the
switch:
Forward position - Turns on the bow lights and the anchor/all around light. This
position will also activate the red light in your compass.
o
1
2
8
9
If you have Faria gauges on the dash panel, this function will
illuminate the gauge lights.
3
4
5
10
11
12
6
13
17

Advertisement

Table of Contents
loading

Table of Contents