Table of Contents
Advertisement
waste either overboard or to your marina's dockside discharge facilities. Before utilizing the dockside or
overboard discharge functions, make certain that the "Y" valve is in the correct position.
The "Y" valve is installed on the port side of
the pump, just outside the view of the above
photo.
It allows you to switch back and
forth between dockside and overboard
discharge. The photos below show the 2
positions for the "Y" valve (i.e., dockside
discharge vs. overboard discharge).
Dockside Discharge - When at a marina that offers dockside
discharge, the marina will provide the external facilities needed to
perform the dockside discharge operation. To operate the dockside
discharge, turn the "Y" valve to the dockside discharge position as
shown at the right.
The "Y" valve for the Electric Head as shown here is set to use
dockside discharge. Follow the arrows. Waste is going from the
holding tank, to the "Y" valve and then upward to the waste outlet.
The waste outlet is a stainless steel fitting, labeled waste. It is located amidships on the starboard
gunwale. Twist the waste outlet cap to open the fitting and insert the hose provided by the marina into
the waste outlet to connect to your marina's dockside service facilities. Follow the instructions provided
by the marina to operate their equipment.
Overboard Discharge - To operate the overboard discharge, turn the
"Y" valve to the overboard discharge position. The "Y" valve for the
Electric Head as shown here is set to use overboard discharge.
Follow the arrows. Waste is going from the holding tank, to the "Y"
valve and then to the electric head pump.
Then, go into the head area and flip the macerator switch to the on
position.
Before using the overboard discharge system, be sure to check with your local authorities, U.S. Coast
Guard, local marina or your dealer for the rules and/or laws that may apply specifically in your area.
Before operating the electric head system, refer to the manual in your owner's packet supplied by the
electric head manufacturer for specific operating instructions.
Warning: Waste in the holding tank can form methane, an explosive gas. Use suitable
precautions when any maintenance is done to the sanitary system.
Fuel/Oil Systems
Fuel Tank
The 192-gallon fuel tank on your Pro-Line is constructed of heavy gauge aluminum with internal baffling
to minimize sloshing. The fuel tank is located under the deck and is secured between the stringers and
bulkheads.
Electric Head
Pump
Seacock
Lever
Waste Tank
28
Advertisement
Table of Contents
