Table of Contents
Advertisement
Center Console w/Enclosed Head (Porta-Potti)
This porta-potti comes equipped with a 2.8-gallon holding tank. To operate the porta-potti system:
•
Set the portable toilet on its front side so the cap on the holding tank is in a vertical
position. Remove the cap and add SeaLand brand holding tank deodorant following the
instructions on the deodorant container. Replace the cap firmly.
•
Before using: Set the portable toilet in the upright position and remove the cap located
on the right rear side of the fresh water tank. Fill with fresh water just below the neck of
the fresh water inlet. Depress the bellows pump to add water to the bowl.
•
After using: To flush, open slide valve by pulling out the handle and press the bellows
pump one or more times. After flushing, close slide valve by pushing handle.
•
Caution: Never add holding tank deodorant to the waste holding tank by pouring directly
into the toilet bowl.
Before operating the porta-potti head system, refer to the manual in your owner's packet supplied by the
porta-potti manufacturer for specific operating instructions.
Head – Porta-Potti w/Dockside Discharge (Optional)
This optional head system includes the same porta-potti and 5.2-gallon holding tank, as the one
described above, so be sure to follow the same operating instructions. .
To utilize the optional dockside discharge feature, first locate the waste outlet. It is a stainless steel
fitting, labeled waste and it is located amidships on the port gunwale. Twist the waste outlet cap to open
the fitting and insert the hose provided by the marina into the waste outlet to connect to your marina's
dockside service facilities. Follow the instructions provided by the marina to operate their equipment.
Warning: Waste in the holding tank can form methane, an explosive gas. Use suitable
precautions when any maintenance is done to the sanitary system.
Before operating the porta-potti head system, refer to the manual in your owner's packet supplied by the
porta-potti manufacturer for specific operating instructions.
Electric Head w/Macerator and Holding Tank w/Pump Out (Optional)
If you have selected the optional electric head, your boat is equipped to offer you the option of using
overboard or dockside discharge to pump out the waste tank. This push button operating electric head
system comes equipped with a 7-gallon holding tank, macerator pump, diverter valve ("Y" valve) and
switch panel, and uses sea water for flushing.
The flush control button and the switch panel are installed
on the aft wall of the head area. The flush control button
operates the head, allowing you to flush the waste. The
switch panel has switches for the head and the head
macerator pump.
The head macerator pump, "Y" valve, holding tank and
brass seacock are all installed below the sink area in the
head.
Before attempting to flush the toilet, make sure that the seacock is in the open position. The seacock is
open when the yellow lever is in the full upright position. When the lever is in the horizontal position, the
seacock is closed.
To flush the toilet, first, move the head switch to the on position. Then press the round button labeled
Press to Flush. This action empties the head waste into the holding tank. The head macerator pump is
used in the overboard discharge operation. The "Y" valve must be in the correct position to direct the
Push to Flush
Switch Panel
27
Advertisement
Table of Contents
