Table of Contents
Advertisement
Lighting Systems
Baitwell Light
The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol on the
switch. To turn on the baitwell light, press the switch forward and open the baitwell lid to see if the
baitwell light is on. Press the baitwell light switch to the down or aft position to turn off the light.
Cabin Light
The dealer-installed battery provides power to the cabin light. The light can adjusted to direct the light to
most areas in the cabin. Turn the base of the light to the left to turn the light on and to the right to turn the
light off.
Cockpit Lights (Optional)
The cockpit lights are small circular lights located around the cockpit area
near the helm seat. Locate the 2-way cockpit light switch on the switch panel
and press the switch in the forward position to turn on the cockpit lights. Press
the cockpit light switch in the down or aft position to turn the lights off.
Navigation and Anchor/All Around Lights
The navigation lights consist of a pair of lights that
are mounted at the bow of the boat. The red light
is installed on the port side and the green light is
installed on the starboard side.
The navigation and anchor/all around lights are required to be used for operation at night or under low
visibility conditions to indicate your position to other boaters.
navigation and anchor/all around lights and make sure that the lights are free from obstructions. You
should check your navigation lights monthly during optimum visibility conditions.
•
When you are underway in low visibility conditions, you should have the Nav/Anchor
switch in the up or forward position. This will activate the navigation lights, as well as
your anchor/all around light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor/all
around light. Press the Nav/Anchor switch to the down or aft position to turn on the
anchor/all around light.
Remote Spot Light (Optional)
The remote spot light is mounted to the forward area of the top. To operate the remote spot light, locate
the remote spot light panel that is installed on the console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located
in the center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the
The U.S. Coast Guard requires that the anchor
light be installed at the highest point on the boat
and must be secured in the up position when you
are underway. This light will be installed on top
of the hard top.
Visually verify the operation of your
18
Advertisement
Table of Contents
