Table of Contents
Advertisement
The circuit breakers are installed next to the battery switch panel and are labeled aft bilge, forward bilge,
trim tabs, stereo and accessory.
Place all the switches in the off position.
Turn the ignition key on (both ignition keys for a twin engine application) and ensure that
the engine will not turn over.
Turn the port battery switch to the one (1) position on the switch and turn the port ignition
key to start the port engine.
Turn off the port engine ignition key and the port battery switch.
Then turn the starboard battery switch to the two (2) position on the switch and turn the
starboard ignition key to start the starboard engine.
Never switch battery positions while the engines are running.
To ensure that the battery switch/switches will turn off, place the switch/switches in the off position and try
to start up the engine/engines. When the switch/switches is/are off, you should not be able to start the
engine/engines.
Caution: To avoid possible alternator/battery damage on twin-engine installations, make
sure that the dual battery switches are never left so both engines are connected together,
(i.e., never leave a switch on "BOTH" or "ALL" or "1 and 2"). The preferred switch
position is port engine to position one (1) on the port battery switch and starboard engine
to position two (2) on the starboard battery switch.
12 Volt Receptacle (Optional)
An optional 12-volt receptacle can be installed on the console. It is easily accessible and can be used to
charge your cell phone, operate a hand held remote spotlight, etc.
Lighting Systems
Baitwell Light
The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol on the
switch. To turn on the baitwell light, press the switch forward and open the baitwell lid to see if the
baitwell light is on. Press the baitwell light switch to the down or aft position to turn off the light.
Cabin Lights
There are 2 bullet lights installed in the bow area of the cabin. The cabin light switch is located on the
switch panel on the console. To activate the cabin lights, depress the switch to the up or forward position.
Each light can then be turned on or off individually by turning the base of the light counter clockwise for
on or clockwise for off. When you are finished using the lights, press the cabin light switch to the off
position.
Cockpit Lights (Optional)
The cockpit lights are small circular lights located in the aft cockpit area.
Locate the 2-way cockpit light switch on the switch panel and press the
switch in the forward position to turn on the cockpit lights. Press the cockpit
light switch in the aft position to turn the lights off.
Navigation and Anchor/All Around Lights
The navigation and anchor/all around lights are required to be used for operation at night or under low
visibility conditions to indicate your position to other boaters.
navigation and anchor/all around lights and verify that the lights are free from obstructions. You should
check your navigation lights monthly during optimum visibility conditions.
Visually check the operation of your
19
Advertisement
Table of Contents
