Lighting Systems; Baitwell Light; Navigation And Anchor Lights; Spreader Lights And Courtesy Light (Optional) - Pro-Line Boats 2010 20 Express Owner's Manual

Lighting Systems

Baitwell Light

The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol on the switch.
To turn on the baitwell light, press the switch forward and open the baitwell lid to see if the baitwell light is on.
Press the baitwell light switch to the down or aft position to turn off the light.

Navigation and Anchor Lights

The navigation/anchor lights are required to be used for operation at night or under low visibility conditions to
indicate your position to other boaters. Visually check the operation of your navigation/anchor lights and verify
that the lights are free from obstructions.
conditions.

When you are underway in low visibility conditions, you should have the Nav/Anc switch in the up
or forward position. This will activate the navigation lights, as well as your anchor light.

When you are anchored or in low visibility conditions, you should turn on the anchor light. Press
the Nav/Anc switch to the down or aft position to turn on the anchor light.
The U.S. Coast Guard requires that the anchor light be installed at the highest point on
the boat and must be secured in the up position when you are underway. Therefore,
based upon the optional top that you may have selected, this light will be installed as
follows:

Bimini top – At the forward edge of the motor well.

Hard top – On top of the fiberglass top (shown in photo).
The navigation lights consist of a pair of lights that are mounted at the bow of the
boat. The red light is installed on the port side and the green light is installed on the
starboard side.

Spreader Lights and Courtesy Light (Optional)

The installation of the optional spreader
lights and the dome shaped courtesy light
requires the optional hard top.
spreader lights are mounted to the aft side
of the hard top frame, along the top edge.
The courtesy light is mounted to the bottom
of the hard top storage box.
Two push in switches for the spreader
lights and courtesy light are located on the
base of the courtesy light.

To operate the courtesy light - Press the switch labeled courtesy once to turn on the white
courtesy light. When you press the same switch a 2
off and the red courtesy light (for night vision) will turn on. Press the same switch a 3
turn off the red courtesy light.

To operate the spreader lights - The spreader light switch operates in the same manor as the
courtesy light but only needs to be pressed in once to be turned on and once again to be turned
off.

Cabin Lights

There is a bullet light installed in the cabin. Turn on the cabin light, by turning the base of the light counter
clockwise for on or clockwise for off. When you are finished using the lights, press the cabin light switch to the off
position.
You should check your lights monthly during optimum visibility
Spreader Lights
The
nd
time, the white courtesy light will be turned
Courtesy/Dome Light
rd
time to
14