Lighting Systems; Baitwell Light; Cabin Lights; Cockpit Lights (Optional) - Pro-Line Boats 2008 26 XP Pilot Owner's Manual

11 Cockpit Lights (Optional) – Your vessel may be equipped with cockpit/courtesy lights. The lights
have LED (light emitting diode) bulbs with a lifespan of approximately 10,000 hours. To activate
the lights, depress the switch to the up or forward position. The lights give off a soft warm light
which should not affect your night vision, but will still provide you with enough light to safely move
around your cockpit in low visibility conditions.
12 Cabin Light – The cabin light switch provides power to the bullet lights located in the cabin. To
activate the lights, depress the switch to the up or forward position. Then press the on/off switch
located on the base of the light. The bullet lights can then be turned on individually.
13 Accessory - This 5 amp accessory switch can be used for additional dealer installed accessories.
Please check the amp rating of any new component and/or additional accessory before
installation.

Lighting Systems

Baitwell Light

The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol on the
switch. To turn on the baitwell light, press the switch forward and open the baitwell lid to see if the
baitwell light is on. Press the baitwell light switch to the down or aft position to turn off the light.

Cabin Lights

The cabin light switch provides power to the three (3) bullet lights that are installed inside the cabin. To
operate the lights, depress the cabin light switch on the console to the forward or on position. Each light
can then be turned on or off individually by turning the base of the bullet light to the on or off position.

Cockpit Lights (Optional)

The cockpit lights are small circular lights located at the base of the console
near the helm seat. Locate the 2-way cockpit light switch on the switch panel
and press the switch in the forward position to turn on the cockpit lights. Press
the cockpit light switch in the back or aft position to turn the lights off.
Navigation and Anchor Lights
The navigation and anchor lights are required to be used for operation at night or under low visibility
conditions to indicate your position to other boaters. Visually verify the operation of your navigation and
anchor lights and verify that the lights are free from obstructions. You should check your navigation lights
monthly during optimum visibility conditions.
•
When you are underway in low visibility conditions, you should have the Nav. Lights
switch in the up or forward position. This will activate the navigation lights, as well as
your anchor light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor light.
Press the Nav. Lights switch to the down or aft position to turn on the anchor light.
The navigation lights consist of a pair of lights that are mounted at the bow of
the boat. The red light is installed on the port side and the green light is
installed on the starboard side.
20