Table of Contents
Advertisement
Instrumentation
Compass
The compass is located on the dash on top of the console. To
ensure that the compass light is working properly, press the
Nav/Anc switch in the forward position to turn on the red LED light
inside the compass. When finished, turn the Nav/Anc switch back
to the middle position.
Please refer to the owner's manual provided by the manufacturer
of the compass for operational procedures and for information
related to the care and maintenance of their product. When in
doubt, always defer to the compass manufacturer's instructions
and/or recommendations.
Horn - Electric
The horn is used to signal, warn or alert other boats or persons on shore. The horn switch is located on
the switch panel. The horn device is located on the gunwale just forward of the starboard navigation light.
Depress the horn switch to the up or forward position to activate the horn, then release the horn switch to
deactivate the horn.
dangerous situations to you or someone around you.
See the Safety section in this manual for more information. Avoid any horn use without an appropriate
purpose. Additional information regarding audible warning signals should be covered in a safe boating
course.
Full Instrumentation / Gauges (Digital)
All gauges are installed on the console but the configuration and specific location of your gauges will vary
depending upon the selection of the various optional engine packages. If your engine package includes
analog gauges (i.e., Faria), the gauges will light up when the navigation lights are on. If your engine
package includes digital gauges provided by the engine manufacturer (i.e., Mercury SmartCraft, Honda,
etc.), the gauges will light up only when the engine is on.
Note: For boats rigged with analog gauges (i.e., Faria), the gauge configuration may
include individual gauges for the trim, volt and fuel gauges or a multifunction gauge that
includes these 4 gauge functions. For boats rigged with digital gauges, the trim, volt and
fuel gauges are incorporated into the tachometer gauge.
Tachometer - To ensure the tach is working properly, simply turn the ignition key on and start the engine.
While the engine is idling, the tach should be reading in the proper rpm range recommended for the
engine. Your engine manual will indicate the appropriate RPM range. When you are running at wide-
open throttle, the tach should read near the top end of the recommended rpm range.
Remote
Spot Light
Using different sequences of horn blasts indicates different and sometimes
Remote Spot
Light Control
Panel
21
Advertisement
Table of Contents
