Circuit Breakers; Lighting Systems; Baitwell Light; Cabin Lights - Pro-Line Boats 2007 25 Walk Owner's Manual

gravity and are not connected to a fish box pump. This switch can be used as an additional
accessory switch.
Note: The cap on this switch is labeled fishbox because this gauge and switch
panel is also used on boats where a fish box pump is included as standard
equipment.
13 B aitwell Light - To activate the baitwell light, depress the switch to the up or forward position. This
will activate the LED (light emitting diode) light inside your baitwell tub. It is a soft white light that
will keep your bait moving and lively. It will also help you locate your bait on those early morning
or late night fishing trips. To turn the light off, simply depress the switch to the down or aft
position.
C ircuit Breakers
Circuit breakers and /or fuses protect the wiring on your 25 Walk. In the event a device
stops working, check to see if the circuit breaker is tripped or if the fuse is blown. The
circuit breakers are installed in the following locations:
•
The circuit breaker panel is located on the starboard side of the bilge area and
is accessible via the bilge hatch that is installed on the aft deck. The main
breaker (30 amp) is installed at the bottom of the circuit breaker panel.
•
Breakers and/or fuses for the aft bilge, forward bilge, trim tabs, ste
accessory are installed above the main breaker.
•
Additional breaker switches are also located on
individual switches. See the Switch and Breaker Panel information later in this
section for additional information.

Lighting Systems

B aitwell Light
The Baitwell Ligh t switch is located on the switch panel and is labeled Baitwell with a light symbol on the
switch. To turn on the Baitwell Light, press the switch forward and open the Baitwell lid to see if the
Baitwell Light is on. Press the Baitwell Light switch to the down or aft position to turn off the light.
C abin Lights
There are 2 bulle t lights installed inside of the cabin. The cabin light switch is located on the switch panel
on the console. To activate the cabin lights, depress the switch to the up or forward position. Each light
can then be turned on or off individually by turning the base of the light counter clockwise for on or
clockwise for off. When you are finished using the lights, press the cabin light switch to the off position.
C ockpit Lights (Optional)
The cockpit lights are small c
Locate the 2-way cockpit light switch on the switch panel and press the
switch in the forward position to turn on the cockpit lights. Press the cockpit
light switch in the aft position to turn the lights off.
N avigation and Anchor / All Around Lights
The navigation and anchor/all around lights are re
visibility conditions to indicate your position to other boaters.
navigation and anchor/all around lights and verify that the lights are free from obstructions. You should
check your navigation lights monthly during optimum visibility conditions.
ircular lights located in the aft cockpit area.
quired to be used for operation at night or under low
reo and
the switch panel beneath the
Visually check the operation of your
19