Table of Contents
Advertisement
switch. Turn either one of the knobs to raise the float to engage the bilge pump. If the pump comes on,
the automatic float is operating properly.
automatic float switch monthly.
If for some reason the indicator light on your bilge pump switch comes on, check your bilge for water. It is
not uncommon for rain water or water from washing your boat to accumulate in the bilge. Standing water
will activate the automatic float that is connected to the bilge pump. If you notice your pump running
frequently during your day on the water, you should check the thru hull fittings, hose connections, etc. for
any possible leaks.
Keep the bilge area clean and free from debris that could clog ports or inhibit float movement. Also, keep
the battery (starboard) that provides power to the bilge pump charged. If the battery is not charged and
flooding occurs, the boat could swamp causing damage and possible loss of life or property.
Baitwell Pump
The baitwell switch at the helm controls the baitwell pump (800 gph), which is mounted on a seacock in
the bilge area. The baitwell pump and seacock are accessible via the bilge hatch. Raw water for the
baitwell tub comes through the seacock, to the baitwell pump and then to the baitwell tub.
Before turning the pump on from the helm, check to be sure that the seacock is open. The seacock is
wide open when the yellow seacock lever is vertical. When the yellow seacock lever is horizontal, the
seacock is closed. The seacock should remain closed when the baitwell pump is not in use.
Baitwell pump
is shown with
the seacock
open.
To turn the baitwell pump off, press the baitwell switch to the aft position. You should always turn the
baitwell switch off at the helm if the pump is not going to be used soon.
If you find it necessary to run the baitwell pump while you are underway, you may be forcing more water
than necessary up through the seacock. In this instance, adjust the seacock lever to a 45 degree angle
so that the seacock is only halfway open. The seacock lever may require additional adjustments to find a
setting that works best for you. Even when the baitwell pump is turned off, if the seacock is open, the
baitwell tub will continue to fill with water while you are underway.
It is recommended that you check the operation of each
The hose on the
lower port feeds
raw water to the
washdown pump.
is located in aft
To operate the baitwell pump, locate the baitwell switch on
the console and press the switch to the forward position to
turn on the pump. When the baitwell pump is operating, go
to the baitwell tub and visually check to see if water is
pumping into the tub through the aerator fitting. This will
ensure that the baitwell pump is working properly.
The 45-gallon capacity baitwell tub is located below the
transom seat. It comes equipped with an aerator head, 2
overflow drains that allow circulation to keep bait alive, a
plug for the drain and a baitwell light.
Baitwell pump
bilge area.
23
Advertisement
Table of Contents
