Programming A Relay Broadcast Initiation - Muratec F-100 Operating Instructions Manual

Beyond the basics

Programming a relay broadcast initiation

Note: To erase a programmable one-touch key, refer to page 2.43.
Note: For this operation to work, three things must be true:
• The remote fax machine must be a Muratec fax machine (other than an
F-86) with "hub" capability.
• The call group(s) to which you're faxing must exist on the remote machine.
• You must know the two-digit number for each call group to which you're
faxing.
To program a relay broadcast initiation into a programmable one-touch key:
1
Press / , , 1,
PROGRAM C ENTER
Select Program No.
... or indicates a command already is programmed into this key.
If 01 is the key you want to program, skip to step 3. (However, our examples
P
from here will say " 05" rather than "
P
2
Select the key in which you want to program a command or change a previ-
ously stored command — if necessary, turn the fliptab to see it, as described
earlier — and then press it. Here, we've selected
Select Program No.
3
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4
Press . The now shows either
ENTER LCD
P05:Fax Number
_
2.40
. The either shows:
LCD
01.")
P
05.
P
P05:Fax Number
or
9-5558743
5
Use the numeric keypad to enter the "hub" machine's number exactly as your
machine should dial it, including whatever codes your phone system may
require. The number can be up to 40 characters in length:
P05:Fax Number
9-5550629
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
scroll leftward or / to scroll rightward.
PROGRAM
Important: Do not press
ENTER
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press
CANCEL
just one character in the number, press
or / to move it rightward, to that character. Then re-enter
PROGRAM
until the number is just as you want it.
6
Now, while you still can see the fax number on the
three times and then press
COMMUNICATION OPTIONS
Relay Tx
Group No. _
7
Use the numeric keypad to enter the two-digit identifier (01–32) for the first
call group. You can specify up to 10 separate groups for each relay broadcast
initiation; between the entry of each new group, press
comma but do not insert a comma after the last group number.
For example, here, we've entered 0, 4,
Relay Tx
Note: The shows only four characters of the group numbers.
LCD
Important: Again, do not insert a comma after the last group number.
When finished, press .
ENTER
8
If you want the transmission to begin immediately every time you press the
key, press and skip to step 11.
ENTER
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS
.
to erase leftward. Or, if you want to change
to move the cursor leftward,
, press
LCD
. The shows:
ENTER LCD
to insert a
GROUP DIAL
, 1, 1, , 2, 4:
GROUP DIAL GROUP DIAL
, .
ENTER
to