An Introduction To Review Commands - Muratec F-100 Operating Instructions Manual

To redial a voice call (using the optional handset) manually:
1
Obtain a dial tone: either press
2
Press / . When the other person answers, speak to him/her on the
REDIAL PAUSE
optional handset.
Making redial settings
It's up to you how many times the fax redials a number and how long it waits during
redials (that's called the redial interval). Here's how to make those settings:
1
Press / , , 0, 7,
PROGRAM J ENTER
Set # Of Redials
If the number of redialings you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, use the numeric keypad to enter the desired number of
redialings, as few as two or as many as 15. In this example, we've entered 03,
for three.
Set # Of Redials
Important: Notice that you must enter a leading zero when setting a quan-
tity lower than 10.
3
Press to save the setting.
ENTER
4
The now shows:
LCD
Set Redial Interval
If the redial interval (in minutes) you see is acceptable, skip to step 6.
Otherwise, proceed to step 5.
5
To change the setting, use the numeric keypad to enter the desired length (in
minutes). You may enter 3, 4 or 5. In this example, we've chosen 4.
Set Redial Interval
6
Press to save the setting.
ENTER
/ or lift the optional handset.
MONITOR CALL
.

An introduction to Review Commands

To cancel either an in-progress transmission or an automatic redial, you'll use the
Review Commands function. First, a bit of explanation, however . . .
• Because your fax machine can store multiple transmission commands in memory,
it keeps track of each command by assigning it a command number — e. g., "C00."
• When your machine stores a document for either normal sending from the feeder
(i. e., as opposed to using on-hook dialing or a handset) or automatic redial, that
makes that document one of those stored commands.
The Review Commands function gives you the power not only to check on (review)
each command currently pending in your machine's memory but also to delete a
command if you decide not to go ahead with the command and send the document.
1
Press .
REVIEW COMMANDS
The shows the first command, indicated by its command number and the
LCD
phone number the command will dial. If a command is in progress, that will
be the first command the
LCD
C00:5552009
2
If this is the command you want to cancel, skip to step 4.
If this is not the command you want to cancel, proceed to step 3.
3
Press / to continue on to the next command in the command
PROGRAM
queue, then go back to step 2.
4
Press . The shows:
CANCEL LCD
C00:5552009
5
If you do want to cancel this command, press
6
The now shows the next command.
LCD
If you want to cancel it, too, go back to step 4.
If you want to avoid cancelling this command but do want to review other
commands in the queue, press /
If you want to stop reviewing the stored commands, press
machine to standby mode.
This function gives you enormous control over your machine's most powerful features.
For more information on the Review Commands function, please see page 2.22.
shows:
again.
CANCEL
and go back to step 2.
PROGRAM
to return the
STOP
Getting started
1.17