Programming Regular And Database Polling - Muratec F-100 Operating Instructions Manual

9
There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Delayed
Option 2: Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
Delayed
10
Press , .
ENTER ENTER
11
The now displays the next programmable one-touch key.
LCD
If you do not wish to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do wish to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.

Programming regular and database polling

Note: To erase a programmable one-touch key, refer to page 2.43.
Note: For database polling to work, three things must be true:
• The remote fax machine must be a memory-equipped Muratec fax
machine (other than an F-76, F-85 or F-86) with a file stored in its data-
base memory and ready for polling.
• The database file which you're polling must exist on the remote machine.
• You must know the one- or two-digit file number for each database file
you wish to poll.
Note: You cannot program continuous polling into a programmable one-touch key.
For more information on continuous polling, see page 2.32.
on the 30th.")
PM
today.")
PM
STOP
To program a polling operation, whether regular or database, into a programmable
one-touch key:
1
Press / , , 1,
PROGRAM C ENTER
Select Program No.
... or indicates a command already is programmed into this key.
If 01 is the key you want to program, skip to step 3. (However, our examples
P
from here will say " 04" rather than "
P
2
Select the key in which you want to program a command or change a previ-
ously stored command — if necessary, turn the fliptab to see it, as described
earlier — and then press it. Here, we've selected
Select Program No.
3
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4
Press . The now shows either
ENTER LCD
P04:Fax Number
_
5
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The num-
ber can be up to 40 characters in length:
P04: Fax Number
9-5550696
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
scroll leftward or /
PROGRAM
Important: Do not press
ENTER
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press
CANCEL
just one character in the number, press
or / to move it rightward, to that character. Then re-enter
PROGRAM
until the number is just as you want it.
Beyond the basics
. The either shows:
LCD
01.")
P
04.
P
P04:Fax Number
or
9-5557312_
to scroll rightward.
.
to erase leftward. Or, if you want to change
to move the cursor leftward,
to
2.41