Table of Contents
Advertisement
Beyond the basics
Getting everything just the way you want it
The EasyStart feature guided you through the "just-gotta" settings on your machine.
In the next few pages, we'll cover other settings.
Setting up for scans
You can set parameters regarding how your fax machine scans documents for either
faxing or copying:
• Primary transmission mode — Gives you four ways to send faxes, either one
of the three resolution modes — normal, fine or superfine ("S Fine" on the
— or in grayscale mode ("Gray").
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
• Scanning width (F-150 only) — Set how wide an area your fax machine scans
per page.
1
Press /
,
, 0, 1,
PROGRAM
J
Primary:
Normal
Program/Enter
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
mode appears. In this example, we've chosen fine resolution.
Primary:
Fine
Program/Enter
3
Press
to save the setting. The
ENTER
Contrast:
Normal
Program/Enter
If the setting you see is acceptable, skip to step 5.
Otherwise, proceed to step 4.
2.2
. The
asks which resolution you select:
ENTER
LCD
or /
repeatedly until your chosen
PROGRAM
asks which contrast setting you select:
LCD
4
To change the setting, press
setting appears. In this example, we've chosen light contrast.
Contrast:
Program/Enter
If your machine is either an F-120 or F-100, skip to step 7.
If your machine is an F-150, proceed to step 5.
5
Press
to save the setting. The
ENTER
)
LCD
Scan Width:
Program/Enter
For most uses, "
page. However, for documents of unusual width, you may wish to use the "
setting, which scans the central 9.9 of each page. (See "
Glossary beginning on page 3.17.)
If the setting you see is acceptable, skip to step 7.
Otherwise, proceed to step 6.
6
To change the setting, press
setting appears. In this example, we've chosen "
Scan Width:
Program/Enter
7
Press
to save the setting.
ENTER
Of course, you always can change the resolution and contrast before sending. (You
can change the scanning width only through the previously described procedure.)
To adjust the resolution and contrast:
• Press
RESOLUTION
• Press
to change the contrast.
CONTRAST
or /
repeatedly until your chosen
PROGRAM
Light
asks which scanning width you select:
LCD
A4
4" is the proper setting; it scans the central 8.2 of each
A
or /
repeatedly until your chosen
PROGRAM
4".
B
B4
to change the resolution.
4"
B
4,
4,
3" in the
A
B
A
Advertisement
Table of Contents
