Setting Silent Mode; Setting The Transmission Confirmation Stamp - Muratec F-100 Operating Instructions Manual

Beyond the basics

Setting silent mode

If you and your fax machine share a quiet place, you'll really appreciate being able to
put the machine into silent mode. This mutes both the ringer and the "I'm done!" beep
your machine makes after sending or receiving a fax or making a copy.
Note: Let's say it again — silent mode mutes the ringer as well as the beep. So, if
you're using your fax machine as both a fax and phone (with the optional
handset), you may not wish to use this feature.
Note: Of course, turning on the silent mode on your fax machine won't turn off
ringers on other telephones in your house or office. Similarly, other phones
won't distinguish between fax and voice calls.
1
Press / , , 1, 5,
PROGRAM J
Silent Mode:
Program/Enter
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
setting appears. In this example, we've chosen On.
Silent Mode:
Program/Enter
Note: Don't be confused. If silent mode is On, the machine will be quiet.
If silent mode is Off, the machine will ring and beep as usual.
(In other words, the Off/On refers to the silent mode setting,
not to the sound itself!)
3
Press to save the setting.
ENTER
2.6
. The shows your fax's current setting:
ENTER LCD
Off
or / once or twice until your chosen
PROGRAM
On

Setting the transmission confirmation stamp

You can set your fax machine so that it will automatically place a small stamp mark
on the front of each original document that it successfully scans.
Important: Be sure that this feature is turned off if you are sending original docu-
ments you don't want the fax to stamp.
1
Press / , , 2, 0,
PROGRAM J ENTER
Stamp: Off
Program/Enter
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
setting appears. In this example, we've chosen On.
Stamp: On
Program/Enter
3
Press to save the setting.
ENTER
. The shows your fax's current setting:
LCD
or / once or twice until your chosen
PROGRAM