Muratec F-100 Operating Instructions Manual page 92

Printouts have irregularities
ABCDE
• The paper you're using may have absorbed moisture, per-
haps due either to high humidity or water having been
ABCDE
spilled on the paper supply at some point. Toner will not
ABCDE
adhere well to paper at the locations where the paper has
been wet.
ABCDE
Replace the paper with dry paper and try printing again.
ABCDE
Printouts have white and/or black lines
ABCDE
• The toner cartridge or drum cartridge may be defective.
Remove and check the cartridges for damage.
ABCDE
If the problem persists, replace either or both of the car-
ABCDE
tridges as indicated.
• The charger may be dirty.
ABCDE
Your machine normally cleans the charger automatically.
ABCDE
If other solutions fail, please contact your authorized
Muratec dealer or call Muratec Customer Support.
Printouts have toner smudges
ABCDE
• The toner may be unevenly distributed inside the
toner cartridge.
ABCDE
Remove the toner cartridge and shake it a few times to
ABCDE
redistribute the toner inside. If the problem persists, replace
the cartridge.
ABCDE
• The toner cartridge or drum cartridge may be defective.
ABCDE
Remove and check the cartridges for damage. If the problem
persists, replace either or both of the cartridges as indicated.
• If you find smudges on the back of the printouts, the trans-
port roller may be dirty.
Your machine normally cleans the transport roller auto-
matically. If other solutions fail, please contact your
authorized Muratec dealer or call the Muratec Customer
Support Center at (972) 364-3350.
Printouts have white spots
ABCDE
• The charger may be dirty.
Your machine normally cleans the charger automatically.
ABCDE
If other solutions fail, please contact your authorized
ABCDE
Muratec dealer or call the Muratec Customer Support
Center at (972) 364-3350.
ABCDE
ABCDE
Just in case ...
3.5