Table of Contents
Advertisement
2
Select the key in which you want to program a command or change a previ-
ously stored command — if necessary, turn the fliptab to see it, as described
earlier — and then press it. Here, we've selected
Select Program No.
3
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4
Press
. The
now shows either
ENTER
LCD
P08:Fax Number
_
5
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The num-
ber can be up to 40 characters in length:
P08:Fax Number
9-5550629_
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
scroll leftward or /
to scroll rightward.
PROGRAM
Important: Do not press
ENTER
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press
CANCEL
just one character in the number, press
or /
to move it rightward, to that character. Then re-enter
PROGRAM
until the number is just as you want it.
6
Now, while you still can see the fax number on the
,
COMMUNICATION OPTIONS
ENTER
Delayed
08.
P
P08:Fax Number
or
9-5558743_
.
to erase leftward. Or, if you want to change
to move the cursor leftward,
, press
LCD
. The
shows:
LCD
7
There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1:
Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Option 2:
Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
8
Press
,
ENTER
ENTER
9
The
now displays the next programmable one-touch key.
LCD
If you do not wish to enter or change any other key's programming, press
to
to return your machine to its usual standby mode.
If you do wish to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.
Programming a broadcast
Note: To erase a programmable one-touch key, refer to page 2.43.
Programming a broadcast is very similar to programming a delayed transmission
except that, rather than specifying just one phone number, you set up multiple
numbers to which the transmission should go.
To program a broadcast into a programmable one-touch key:
1
Press /
PROGRAM
Select Program No.
... or indicates a command already is programmed into this key.
If
01 is the key you want to program, skip to step 3. (However, our examples
P
from here will say "
Delayed
PM
Delayed
.
,
, 1,
. The
either shows:
C
ENTER
LCD
06" rather than "
01.")
P
P
Beyond the basics
on the 30th.")
PM
today.")
STOP
2.37
Advertisement
Table of Contents
