Ics; Model - AMX NXD-1000Vi Operation/Reference Manual

Intercom Commands (Cont.)

^ICS

^MODEL?

NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Starts an intercom call to the specified IP address and ports.
• Intercom start. Starts a call to the specified IP address and ports, where initial mode is
either 1 (talk) or 0 (listen) or 2 (both).
• If no mode is specified 0 (listen) is assumed.
• Note that no data packets will actually flow until the intercom modify command is sent to
the panel.
Syntax:
SEND_COMMAND <DEV>,"'^ICS-<IP>,<TX UDP port>,<RX UDP port>,
<initial mode>'"
Variables:
IP = IP Address of panel to connect with on an Intercom call.
TX UDP port = UDP port to transmit to.
RX UDP port = UDP port to receive from.
initial mode = 0 (listen) or 1 (talk) or 2 (handsfree). 0 is the default.
Examples:
Example of setting up a hands-free unicast call between two panels:
SEND_COMMAND TP1, "^ICS-192.168.0.3,9000,9002,2"
SEND_COMMAND TP2, "^ICS-192.168.0.4,9002,9000,2"
Example of setting up a multicast call where the first panel is paging two other panels:
SEND_COMMAND TP1, "^ICS-239.252.1.1,9002,9000,1"
SEND_COMMAND TP2, "^ICS-239.252.1.1,9002,9000,0"
SEND_COMMAND TP3, "^ICS-239.252.1.1,9002,9000,0"
Example of setting up a baby monitor call where the first panel is listening to the
microphone audio coming from the second panel:
SEND_COMMAND TP1, "^ICS-192.168.0.3,9000,9002,0"
SEND_COMMAND TP2, "^ICS-192.168.0.4,9002,9000,1"
Gets the panel model name.
Syntax:
"'^MODEL?'"
Example:
SEND_COMMAND Panel,"'^MODEL?'"
The panel (an MVP-8400i) responds with, ^MODEL-MVP-8400i
Programming
185