AMX NXD-1000Vi Operation/Reference Manual page 39

Trim
Ring
Latches
Default Button Trim Ring
(with button openings)
FIG. 17
Removing the default Button Trim Ring
5.
From along the internal surface of the Faceplate, install the two buttons by firmly inserting them into the
button openings until the Button latch secures the button in place (FIG. 18).
6.
Install the pair of clear light pipe strips by pushing light pipes over the two black light pipe latches.
7.
Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the
Faceplate (made available by the removal of the previous Trim Ring).
8.
Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of the
internal Faceplate (FIG. 18).
Button Trim Ring
FIG. 18 Inserting the Button Trim RIng
9.
Firmly press down around the Button Trim Ring until all of the latches are securely inserted into their
openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the Button Trim Ring is
firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring and the outer surface
of the Faceplate.
10.
Place the Faceplate back onto the main NXD-1000Vi unit. Make sure to align the Microphone, Light, and
PIR Motion sensor locations on the main unit to their respective openings on the Faceplate assembly.
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Button openings
NXD-1000Vi Panel/enclosure
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the inside surface of Faceplate)
Faceplate
(outside surface shown)
Faceplate (outer surface shown)
Installation
Button latch
B
25