AMX NXD-1000Vi Operation/Reference Manual page 100

Firmware Pages and Descriptions
EAP-TTLS
EAP-TLS
EAP-LEAP
EAP-FAST
Site Survey:
RF Link Info:
SSID
Channel
Wireless Settings Page (Cont.)
RF Link Info (Cont.):
Link Quality
86
This button opens the EAP-TTLS Settings page (FIG. 81 on page 99).
"EAP-TTLS" security is designed for wireless environments where it is
necessary to first have a Radius server directly validate the identity of the client
(panel) before allowing it access to the network.
• Refer to the Wireless Security Page section on page 83 for details.
• For information on uploading a certificate file, refer to the AMX Certificate
Upload Utility section on page 6.
This button opens the EAP-TLS Settings page (FIG. 82 on page 101).
"EAP-TLS" security is designed for wireless environments where it is necessary
to securely transmit data over a wireless network by adding an additional level
of security protocol via the use of a private key.
• Refer to the Wireless Security Page section on page 83 for details.
• For information on uploading a certificate file, refer to the AMX Certificate
Upload Utility section on page 6.
This button opens the EAP-LEAP Settings page (FIG. 77 on page 93).
"EAP-LEAP" security is designed for wireless environments where it is not
required to have both a client or server certificate validation scheme in place,
yet necessary to securely transmit data over a wireless network.
• Refer to the Wireless Security Page section on page 83 for details.
This button opens the EAP-FAST Settings page (FIG. 79 on page 95).
"EAP-FAST" security is designed for wireless environments where security and
ease of setup are equally desirable.
• Refer to the Wireless Security Page section on page 83 for details.
The Site Survey tool allows you to detect and view detailed information on all
WAPs within the panel's communication area. Using this tool, you can select a
WAP to connect to.
• Refer to the Using the Site Survey tool section on page 42 for information on
using this tool.
These options set communication values for the wireless interface card:
Displays the currently used SSID of the target WAP.
The RF channel being used for connection to the WAP (read -only).
Displays the quality of the link from the wireless NIC to the Wireless Access
Point (direct sequence spread spectrum) in real time (None, Poor, Fair, Good,
Very Good, and Excellent).
• Even when link quality is at its lowest you still have a connection, and the
ability to transmit and receive data, even if at lower speeds.
Note: "Link Quality" and "Signal Strength" are applicable to RF connections
only. It is possible to have an RF signal to a WAP, but be unable to communi-
cate with it because of either incorrect IP or encryption settings.
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom