AMX NXD-1000Vi Operation/Reference Manual page 18

Introduction
Product Specifications (Cont.)
Microphone:
Speaker:
LEDs:
Buttons:
Side Panel Components:
Mini-USB connector:
Stereo Output connector:
Ethernet 10/100 port:
Ethernet 10/100 LEDs:
USB connector:
Audio/Video connector:
PWR connector:
Button Assignments
(NXD-1000Vi only):
Operating / Storage
Environment:
4
• Used for intercom applications
(requires the NXA-AVB/ETHERNET Breakout Box for analog
communication)
• Single 2 watt speaker
• 2 blue LEDs (support On and Off)
- Both the LEDs and pushbuttons are only available when using the Button
Trim Ring on the NXD panel.
• 2 programmable pushbuttons
• 5-pin Mini-USB connector used for programming, firmware update, and touch
panel file transfer between the PC and the target panel.
Note: When connecting the panel to PC using a CC-USB (or compatible)
cable, be sure to power the panel On before attempting to connect the USB
cable from the PC to the mini-USB port on the panel. Refer to the Configure the
panel for USB communication section on page 50 for more
information.
• Stereo output through a 3.5mm mini-jack (for use with external speakers or
headphones).
• RJ-45 port for 10/100 Mbps communication. The Ethernet port automatically
negotiates the connection speed (10 Mbps or 100 Mbps), and whether to use
half duplex or full duplex mode.
• NXD-1000Vi panels communicate with the NetLinx Master using the ICSP
protocol over Ethernet.
• LEDs show communication activity and connection information:
A-activity - Yellow LED lights when receiving or transmitting Ethernet data
packets.
L-link - Green LED lights when the Ethernet cables are connected and
terminated correctly.
• Type-A USB port can connect an external keyboard or mouse device for use
with Virtual PC applications.
Note: External USB input devices (keyboard or mouse) must be plugged into
the rear/side USB connector before the unit is powered-up. The panel will not
detect these USB input devices until the unit cycles power.
• RJ-45 connector for communication of differential audio/video signals
to/from the touch panel (panel type dependant). This connector receives
Composite video, Stereo (left/right) audio, and microphone audio.
• Video is received via the NXA-AVB/ETHERNET Breakout Box. Configuring
video windows for playback is done using TPDesign4.
• In-bound audio (from the breakout box) gets directed to the speakers.
• Out-bound audio is sent from the on-board microphone (on the
front-panel). Selecting audio files for playback is configured through
TPDesign4.
• 2-pin 3.5 mm mini-Phoenix connector.
Button assignments can only be adjusted in TPD4 and not on the panels.
• Button channel range: 1 - 4000 button push and feedback (per address port)
• Button variable text range: 1 - 4000 (per address port)
• Button states range: 1 - 256 (General Button; 1 = Off State, 2 = On State)
• Level range: 1 - 600 (default level value 0-255, can be set up to 1 - 65535)
• Address port range: 1 - 100
• Operating Temperature: 0° C (32° F) to 40° C (104° F)
• Operating Humidity: 20% - 85% RH
• Storage Temperature: -20° C (-4° F) to 60° C (140° F)
• Storage Humidity: 5% - 85% RH
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom