Mps; Tps - AMX NXD-1000Vi Operation/Reference Manual

Input Commands (Cont.)

^MPS

^TPS

^VKS
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Set mouse pass through. Allows mouse input to multiple destinations simultaneously.
• Destinations are comma delimited.
Syntax:
"'^MPS-<0-6>,<0-6>,...'"
Variables:
0 = Pass mouse input to G4 application.
1-4 = Pass mouse input data to a VGA card with USP output for redirection to a
computer.
5 = Pass mouse buttons to the NetLinx master in the form of a custom event.
6 = Pass mouse buttons and movement to the NetLinx master in the form of custom
events.
Example:
SEND COMMAND Panel,"'^MPS-0'"
Passes the mouse input to a connected G4 application.
Note: This command causes all mice connected to the G4 product and any mice on a
computer connected via a VGA card with USB output to reset to position 0,0.
Set touch pass through.
Syntax:
"'^TPS-<0-1>'"
Variable:
1 = Creates a transparent connection between the touch input serial port and the
program port.
This is useful for connecting a PC to the program port and controlling touch input on that
PC from the touch panel connected to the touch input port.
This will cause the command terminal on the program port to shutdown.
0 = Undoes the changes.
Example:
SEND COMMAND Panel,"'^TPS-1'"
Enables the touch pass through.
Send one or more virtual key strokes to the G4 application.
• Key presses and key releases are not distinguished except in the case of CTRL, ALT,
and SHIFT.
• Refer to the Embedded Codes table on page 178 that define special characters which
can be included with the string but may not be represented by the ASCII character set.
Syntax:
"'^VKS-<string>'"
Variable:
string = Only 1 string per command/only one stroke per command.
Example:
SEND COMMAND Panel,"'^VKS-'8"
Sends out the keystroke 'backspace' to the G4 application.
Programming
177