Table of Contents
Advertisement
Programming
Intercom Commands
The following is a listing and descriptions of panel intercom commands.
Intercom Commands
^ICE
Ends an
intercom call.
^ICM
Modifies an
intercom call.
^ICS
Starts an
intercom call to
the specified IP
address and
ports.
^MODEL?
Gets the panel
model name.
150
Syntax:
"'^ICE'"
Example:
SEND_COMMAND Panel,"'^ICE'"
Ends a call.
For backwards compatibility, both ^ICM-TALK and ^ICM-LISTEN are supported. In this
release, however, the TALK and LISTEN subcommands are ignored. The microphone
and/or speaker are activated based on the initial mode value of the intercom start
command and the audio data packet flow is started upon receipt of this command by the
panel.
Syntax:
SEND_COMMAND <DEV>,"`^ICM-TALK`"
Variables:
None.
Example:
SEND_COMMAND TP1,"`^ICM-TALK`"
^ICS-<IP>,<TX UDP port>,<RX UDP port>,<initial mode>'"
Intercom start. Starts a call to the specified IP address and ports, where initial mode is
either 1 (talk) or 0 (listen) or 2 (both). If no mode is specified 0 (listen) is assumed. Please
note, however, that no data packets will actually flow until the intercom modify command is
sent to the panel.
Syntax:
SEND_COMMAND <DEV>,"'^ICS-<IP>,<TX UDP port>,<RX UDP
port>,<initial mode>'"
Variables:
IP = IP Address of panel to connect with on an Intercom call.
TX UDP port = UDP port to transmit to.
RX UDP port = UDP port to receive from.
initial mode = 0 (listen) or 1 (talk) or 2 (handsfree). 0 is the default.
Examples:
Example of setting up a handsfree unicast call between two panels:
send_command TP1, "^ICS-192.168.0.3,9000,9002,2"
send_command TP2, "^ICS-192.168.0.4,9002,9000,2"
Example of setting up a multicast call where the first panel is paging two other panels:
send_command TP1, "^ICS-239.252.1.1,9002,9000,1"
send_command TP2, "^ICS-239.252.1.1,9002,9000,0"
send_command TP3, "^ICS-239.252.1.1,9002,9000,0"
Example of setting up a baby monitor call where the first panel is listening to the
microphone audio coming from the second panel:
send_command TP1, "^ICS-192.168.0.3,9000,9002,0"
send_command TP2, "^ICS-192.168.0.4,9002,9000,1"
Syntax:
"'^MODEL?'"
Example:
SEND_COMMAND Panel,"'^MODEL?'"
The panel (an MVP-8400i) responds with, ^MODEL-MVP-8400i
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
Advertisement
Table of Contents
