Assigning Attributes To Numbers - Swisscom Top A47 ISDN Operating Instructions Manual

Phonebook

Assigning attributes to numbers

This section is based on the previous chapter »Enter number and name only«.
As described in the previous section, enter a name and confirm. »No.:« and the cursor is shown.
and underneath »ok, Attributes, del«.
If you have made a mistake you can correct it by pressing the minus button until you
reach the error. Press the softkey under »del« to delete the incorrect letter/number. Make
your correction. Use the plus button to go to the end of your entry.
Keypad (ISDN control functions).
All other attributes apart from »Subaddress« must be entered before entering the number.
Keypad entry
The second line of the display shows »No:« and the cursor, and underneath
»ok, Attributes«. You have not yet entered any phone number.
Press the softkey under »Attributes«.
Attributes
Press the softkey button under » « until »Keypad« is displayed.
Press the softkey under »Keypad«. The second line of the display shows »No.:«
Keypad
along with a »K«.
Enter the keypad code. If necessary, press the star button, enter the code and
then, if required, the hash button. Repeat this procedure if several attributes
are available.
Continue from »Continue entering numbers«.
Enter provider
The first line of the display shows »No.:« and the cursor, and underneath »ok, Attributes«. You
have not yet entered any phone number.
Press the softkey under »Attributes«.
Attributes
Press the softkey button under » « until »Provider« is displayed.
Press the softkey under »Provider«. The second line of the display shows »No.:«
Provider
along with a »P«.
Enter the provider number (1, 2, 3, 4, 5 or 6). To program a provider number
along with the provider, see »Automatic provider preselection«.
Continue from »Continue entering numbers«.
47