Function Menu; Phase Set; Phase Trim - GRAUPNER mz-32 HoTT Reference Manual

FUNCTION Menu

Tap on the document icon to copy the Phase settings to another Phase.
Select a Phase by tapping on the Phase number and then use the Up/Down arrows to
change the Phase priority.
Tap on the circle arrow icon to reset the Phase to the default settings.
Tap on the pencil icon to edit the Phase name.
In the Ctrl column you can assign a switch (Input Control) to activate the Phase.
The Delay setting determines how long it will take until the Phase takes full effect. The
change will happen gradually, determined by the Delay setting.
The Voice checkbox enables a voice announcement when the Phase is activated. You can
keep the default voice file or select your own from the available voice files.
Tap on the Voice file name to select a new or change the existing voice file. If a voice file
was already assigned, the name is highlighted. To change to a different voice file, tap the
X in the upper right corner to deselect the current voice file. Select a new voice file by
tapping first on the file name and then on the check mark icon (upper right corner) to
activate your selection. Tap on the exit icon (closing door in upper right corner) to return
to the Phase Set menu.
You can test/listen to the selected phase announcement by tapping on the Play icon.
If you do not wish to have the motor active during a phase, tap the Motor checkbox which
will deactivate the motor for the phase. For example, this can be used by sailplane pilots
during landing approach, when the sailplane is in a butterfly configuration.
F01S1
dependent in the Group column. Tapping on the group icon will toggle between the global
and phase-dependent setting.
Graupner mz-32 Help Reference Manual

PHASE SET

With phases you can create selectable custom settings
for specific needs/configurations while operating your
model.
A Phase with the higher number, as displayed in the Pri
column, has priority over a lower numbered Phase.
Tap Add a Phase by tapping on the number left of the
phase name. The edit toolbar will be displayed.
Tap on the plus sign to add a phase. You can select
from a list of pre-set phase names or chose the blank
(---) which can be renamed later.
Tap on the trash can icon to delete the phase.

PHASE TRIM

The Phase Trim settings enables you to have different
control surface deflections for each flight phase. For
example, sailplane pilots can set their camber settings
for each control surface or jet pilots can add aileron up
deflections to reduce speed during landing.
The control surfaces available for selection in the
Function column depends on your Model Type settings.
Select
corresponding field in the Function column. You will
notice that the selected control surface is indicated by
the red arrows in the View image.
Phase trims are set by default as flight phase
Page 17 of 42
a control surface by tapping on the
Help-Ref-EN-V1.0