Trim Menu - GRAUPNER X-8N Manual

TRIM menu

SUB: With this trim function, the entire servo travel is moved, i.e. the position of the full deflections
also changes.
SW: Here, the switch is shown (e.g. TR1) which has been assigned to the function "ST SUBT"
or "TH TRIM" in the SW FUN menu. Changes in the settings are directly shown on the display.
(A trim button or a rotary control can be assigned)
B.R.A. menu (ATL)
24
If you have highlighted the field
and then 3x press the INC button, Trim offset appears in
the 2nd line. Using the UP/DOWN
buttons you can move the entire curve up or down.
In this menu, the trimming for each channel can be
performed. (By pressing the DOWN button after 3CH, 4CH
will be visible, which is usually outside the display range.)
SW shows the buttons assigned for trimming in the SW FUN
menu.
ST: RT - LT (+ right or - left deflection)
TH: FW - BW (+ forward or - backward deflection)
MAIN: With this trim function, only the centre of the servo
will be moved, the full deflections remain unchanged.
In this menu, the travel distribution for the brake travel and
the throttle travel in the throttle channel can be set. Also, the
size of the brake range can be defined.
RATE: 50:50 - 70:30 with the setting 70:30, the servo
centre is moved. (Default setting: 50:50)
B.R.A.: 0 - 100% Here, the size of the brake range is
defined.
0% in the POINT line