Dell PowerVault ML6000 Maintenance Manual page 87

6 Unpark the robot assembly.
a. Gently raise the robot assembly so that it no longer rests on the parking tab.
CAUTION
b. With your free hand, move the parking tab to the "unparked" position so that it is removed
completely from the interior of the module (Model 1 parking tab: swivel the parking tab away
from you; Model 2 parking tab: move in a clockwise direction). When replaced correctly, the
parking tab will not accidentally swivel into the path of the robot.
c. Gently release the robot assembly. It will lower to the bottom module of the library.
7 Connect all power cords, network data cables, and module-to-module cables. Make sure the module
terminators are installed at the top and bottom of the stack of modules. For cabling instructions, see
Cabling the Library
8 Power on the library.
9 Reconfigure the library, including applying the new COD license key, using the operator panel or Web
client.
10 Recreate any partitions you deleted prior to installing the module.
11 Add the tape cartridges to the library's modules using the I/E station commands from the operator panel
or Web client.
12 Open the host application and reinventory to synchronize its logical inventory with the physical inventory
of the library. Due to the way the library logically addresses its tape drives and slots internally (see
Understanding Logical Element Addressing
PowerVault ML6000 Maintenance Guide
Support the robot assembly by holding onto the broad metal X-axis
base plate. Lifting the robot by the thin metal rod will bend the rod.
Lifting the robot by the black plastic picker body can damage the
robot.
Model 2 tab
on page 22.
Model 1 tab
on page 543), adding an expansion module will change the
69