Setting Frequency With Operation Panel - Panasonic VF200 Instruction Manual

4. Operation Method (Basic Operation)

4.5 Setting Frequency with Operation Panel

There are 2 modes to set frequency with operation panel as follows.
■ Potentiometer Setting Mode (Parameter P004 is set to "0": factory setting.)
Adjust the position of potentiometer dial on operation panel to make setting.
MIN. position stands for operation stop (0V stop: see parameter P101), while
MAX. position for the maximum frequency.
■ Digital Setting Mode (Parameter P004 is set to "1".)
Press MODE button on the panel to enter frequency setting mode (display: Fr);
press SET button and display the frequency to be set by pressing UP and DOWN
buttons and then press SET button again to complete the setting. Also, the
following "MOP function" can be used for frequency setting during operation.
MOP function
The frequency can be changed by pressing and holding UP or DOWN button
during operation. However, if parameter P003 is set to "1", this function does not
work.
The operation will vary according to the settings of "Parameters" P154: MOP
Function Select" and "P155: MOP Operation Acceleration/Deceleration Time".