8. Press
button to enter "operation ready" status.
That's to say, the inverter is in normal stop status and can
be operated if required. (Operation Status Display Mode)
• If data is written into the built-in non-volatile memory of inverter when setting
and changing operation, it can be stored even if the power is cut off. The built-in
non-volatile memory of inverter can be written up to100,000 times. Therefore,
do not change parameter settings frequently.
• If you change the parameters that cannot be set during operation when the
operation signal is ON, "P.Err" will flicker in the display part first. And after 2 s,
the display will return to parameter No. again. That's to say, the inverter starts
operation without changing the parameter.
6. Function Parameters
83