Monitoring The Outdoor Unit Alarm History: Display Of Outdoor Unit Alarm History; Setting Modes: Setting The Outdoor Unit Eeprom - Panasonic Shows U-26PE1U6 Technical Data & Service Manual

5-5. Monitoring the Outdoor Unit Alarm History: Display of Outdoor Unit Alarm History

* Displays outdoor unit alarms only. Does not display indoor unit alarms.
* Check the indoor unit alarm histories separately using the indoor unit remote
controllers or other control device.
<Operating procedure>
(1) Press and hold the button and
to change to outdoor unit alarm history mode.
During the alarm history display, "Service Check" is lit.
The display and operations are the same as the monitoring of the alarm device
history that is performed using the unit remote controller. However, the outdoor unit
address appears instead of the unit No.
(2) Press the button and select the outdoor unit for alarm history monitoring.
(3) Use the temperature setting
The display shows the address of the selected outdoor unit, the item code, and the alarm history (alarm data).
The outdoor unit address is displayed as system XX-YY.
System XX = Outdoor unit system address
YY = Outdoor unit sub-bus address
The item code is displayed as 01– 08. 01 indicates the most recent alarm.
The alarm history is indicated by the alarm code. (If there have been no alarm codes, "
(4) To clear the alarm history, press the
(5) To end, press the button. The display returns to the normal remote controller display.

5-6. Setting Modes: Setting the Outdoor Unit EEPROM

Setting mode 1
<Operating procedure>
(1) Press and hold the button and
onds or longer.
(2) Use the temperature setting
The item codes and setting data are shown in the table on the next
page.
(3) Use the timer time and
To confirm the changed setting data, press the
(At this time, "Setting" stops blinking and remains lit.)
(4) During this mode, "Setting" is displayed, blinking. The outdoor unit
address display section displays "ALL," the item code and number (DN
value in the table), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between
the first 3 digits (Fig. ) and the last 3 digits (Fig.
A
When the first 3 digits are displayed, the top point of the colon is lit.)
(5) To end the setting mode, press the
button simultaneously for 4 seconds or longer
and buttons to select the item code for the alarm history.
button. (The outdoor unit alarm history will be cleared.)
button simultaneously for 4 sec-
and buttons to change the item code.
buttons to change the setting data.
button.
B ).
button.
5-7
5. Outdoor unit maintenance remote control
A Display of first 3 digits
(5)
(1) (3)
Display of last 3 digits
B
and
A B
(Example shows display of 000 001.)
(3)
(5)
(1) (4) (2)
" is displayed.)
(2)
are displayed alternately.
5