Log On To The Controller Applications - Oce TCS500 User Manual

Log on to the controller applications

User modes
The Océ Power Logic
Key operator
Repro operator
System administrator
Service operator.
Chapter 1 contains more information about the types of users
users' on page
Océ Settings Editor
on to the correct user mode in the Océ Settings Editor to change the key operator
settings or the system administrator settings.
Only assigned operators are allowed to use the user modes. Different passwords are
required to access the user modes.
You do not need a password for the anonymous user mode.
Passwords
The default password for the system administrator is SysAdm .
The default password for the key operator is KeyOp .
The default password for the repro operator is ReproOp .
When a user is logged on, the user can change the password for the current user
mode. (see 'Change the password' on page
Note: The passwords are case sensitive.
Authorisation
Only one key operator, system administrator or repro operator at a time is authorised
to change the settings.
An error message appears when a second user tries to log on to the key operator
mode or system administrator mode.
There is no limitation of users authorised to view the settings.
[95]
[95] Error message when a second user tries to log on
®
controller has the following user modes.
19). Chapter 5 contains more information about the user modes in the
(see 'Introduction to the Océ Settings Editor' on page
Log on to the controller applications
(see 'The Océ TCS500
123)
74). Log
121