Optimise the output quality
Optimise the output quality on the printer
Introduction
This section describes different methods that you can use to optimise the output
quality on the Océ TCS500 printer.
Problem analysis and solutions
[84]
[84] Problem analysis and solutions
Problem
The colour of one
area merges with
the colour of
another area
The colour of one
line runs into the
colour of another
line
Optimise the output quality on the printer
Method of
analysis
'Quality check'
print
'Quality check'
print
Solutions
The media type defined on the
printer must be the same as the
media available on the printer. When
the media type defined on the printer
is not the same as the media
available on the printer, use the
'Change media type' wizard to
change the media type
the media' on page
Use coated media
Use the default drying time
Remove the printer from high
humidity conditions.
The media type defined on the
printer must be the same as the
media available on the printer. When
the media type defined on the printer
is not the same as the media
available on the printer, use the
'Change media type' wizard to
change the media type
the media' on page
Use coated media
Use the default drying time
Remove the printer from areas of
high humidity.
(1 – 4)
(see 'Replace
239)
(see 'Replace
239)
211