Turn On And Off The Océ Tcs500; Troller - Oce TCS500 User Manual

Turn on and off the Océ TCS500 printer and the Océ Power Logic® Controller
Turn on and off the Océ TCS500
Turn on and off the Océ TCS500 printer and the Océ Power
®
Logic Controller
Introduction
The Océ Settings Editor application contains an important setting for the start up and
shut down of the printer and Océ Power Logic
The path of the setting is the following.
Key Operator - Printer - Settings - Synchronise controller power on / off.
Depending on this setting, you can turn on and off the Océ TCS500 printer and the
Océ Power Logic
You can define if this setting is 'On' or 'Off'.
The following paragraphs describe how to turn on and off the Océ TCS500 when the
above setting is set to either 'On' or 'Off'.
The Océ TCS500 printer and Océ Power Logic
that enable you to prevent unnecessary power consumption when the system remains
turned on in an idle state
sleep mode timer' on page
Note: The Océ TCS500 printer has a separate main power switch on the backside
of the printer. Set this main power switch to the position 1, after you connect the Océ
TCS500 printer to the main power supply with the main power cable.
The main power switch must be set to the position 1, before you can turn the system
on, as described below
Only set the main power switch to the position 0 if you want to disconnect the Océ
TCS500 printer from the main power supply, for example in case you want to move
your printer to another location or in case your printer will not be used for a longer
period of time (weeks).
®
controller together or separately.
(see 'The energy save mode timer' on page
60).
®
controller.
®
controller have 2 energy save modes
58) an (see 'The
49