Table of Contents
Advertisement
Remove jammed media
Remove jammed media
Introduction
When a media jam occurs, the system produces a double audio signal. The red LEDs
of the printer operator panel remain illuminated. When a jammed media error occurs
on the system, immediately remove the jammed media to prevent damage to the
printer.
The system handles the error recovery for the jammed media through a series of
dialogue boxes. Use the following procedure to remove the jammed media.
How to remove jammed media
Attention: Never use a knife to cut loose the jammed media. When you use a
knife to cut loose the media, you can damage the printer.
Open the cover or door that the printer operator panel indicates.
1.
[213]
Use a pair of scissors to cut loose the media.
2.
Remove the jammed media from the output side of the printer.
3.
[214]
Press the softkey for 'Done' to confirm that you removed the jammed media.
4.
Close the cover or door that the printer operator panel indicates.
5.
266
Chapter 12 System messages and solutions
Advertisement
Table of Contents
