Install Océ Remote Logic® on your system
Introduction
The Océ Remote Logic
Machine. This section describes the installation procedures for the different types of
platforms.
Before you begin
To install Océ Remote Logic
be at least equipped with a 233 MHz processor with 32 Mb RAM.
Installation procedure for Microsoft® Windows® platforms
Insert the Océ Remote Logic
1.
CD-ROM into the CD-ROM drive of your PC.
The installation starts automatically. If does not start automatically, run Setup.exe.
2.
Select the required language in the installation wizard and click 'OK'.
3.
[94]
[94] Select the setup language
Follow the instructions on the screen to complete the installation of Océ Remote
4.
®
Logic
.
Note: You can only use Océ Remote Logic
Refer to your system administrator for help with the installation procedure for
TCP/IP.
Installation procedure for UNIX platforms
Check if a Java Runtime Environment (JRE) is installed on the system.
1.
From the directory Products/remotelogic/UNIX , unpack the contents of the file
2.
RemoteLogic_vX.tar to a subdirectory on the system.
Use tar xvf RemoteLogic_vX.tar to unpack the file.
3.
Set the environment variable RL_VM_HOME to point to the installation of the
4.
JVM.
Install Océ Remote Logic® on your system
®
application can run on all platforms with Java Virtual
®
®
on Windows
®
CD-ROM or the Océ Power Logic
®
when TCP/IP is enabled on your system.
NT, ME, XP, or 2000, your system must
®
controller
115