Set Up Unattended / Overnight Printing Optimisation - Oce TCS500 User Manual

Set up unattended / overnight printing optimisation

Introduction
The Océ TCS500 has the possibility to print unattended, for example outside office
hours. To use this option, the setting Key Operator - Printer - Settings -
Calibration - Overnight printing optimisation in the Océ Settings Editor must be
set to 'On'.
When the setting 'Overnight printing optimisation' is set to 'On', the system will
automatically perform checks, after the selected number of prints, to ensure a
consistent output quality. For each check, the system uses a approximately 25
centimetres of the loaded media roll.
Set up overnight printing
The setting 'Overnight printing optimisation' has the following options.
[63]
Setting
'Off'
'On'.
Calibration is only possible when one of the following media types are loaded on the
system.
Draft paper
Standard paper
Premium coated paper
Bond
Coated bond
Matt photo paper
High gloss photo paper
Deluxe bond
Recycled plain paper
Plain paper coated
Note: When these media types are not available on the system, the check is delayed
until the next time a print is made on one of these media types.
Set up unattended / overnight printing optimisation
Function
The system will not check the output quality.
The system checks for failing printhead nozzles and corrects the
alignment.
You can define the number of prints after which the system
automatically does a check.
157